The following is the most common method of straight butt stainless steel door cover. The general precautions are as follows:


1) The material thickness is recommended to be 1.2 thick (the actual thickness should not be less than 1.08)


2) Care must be taken to use vertical material to close the door.


3) Pay attention to the fact that the base layer must be about 5mm smaller than the edge size of the door cover to ensure sufficient space for installation and glue application.


4) The width of the door headboard should be slightly smaller than the vertical material width of 1-2 millimeters, and the closing is beautiful.


5) It is not recommended to use glue to close the female corners of the butt joints between the door headboard and the stand breadboard. This is both beautiful and can check the quality of the door cover installation.

The conventional door holster method is shown in the figure above. The disadvantages of this method are:

1) It is difficult to get stuck when the grassroots are not accurate;


2) The size is not adjustable, and the size of the stainless steel door cover cannot be changed when the door base is changed.


3) The processing is complicated, and there is a risk of deformation when the size is large.


It is recommended to use the above picture, this kind of practice is a bit:

1) When the grassroots level is not accurate, it can be effectively resolved by structural decomposition.


2) The width of the door sleeve can be adjusted in a small range, which can adapt to the site changes.


3) After the size is decomposed, the processing difficulty and the risk of deformation are reduced.

General considerations are as follows:

1) The material thickness is recommended to be 1.5 thick (the actual thickness should not be less than 1.38).


2) The width of the door headboard is preferably smaller than the width of the breadboard, so that the closing will be beautiful.


3) Pay attention to the fact that the base layer must be about 5mm smaller than the edge size of the door cover to ensure sufficient space for installation and glue application.


4) It is not recommended to use glue to close the female corners of the butt joints between the door headboard and the stand breadboard. This is both beautiful and can check the installation quality of the door cover.